Skip to content
VFD & industrial
electronics repair

ABB · independent repair

ABB drive repair

ABB drives are our largest single repair line, by a wide margin in our own billing records. ACS550 and ACS800 units come in from steel, forging and auto-component plants every week, and ACS880 drives increasingly as plants upgrade.

We work on them at component level: the IGBT stage, gate drivers, DC bus, control and interface boards, and the keypad. Where the drive supports it we save the parameters before we start and restore them afterwards.

ABB drive internals opened for repair
Fig. 01ABB drive opened for repair
ABB series we repairWorkshop
Compact
ACS150, ACS310, ACS355, ACS380, ACS480
Industrial
ACS510, ACS550, ACS580, ACS800, ACS850, ACS880
HVAC / pump
ACH550, ACH580
DC drives
DCS550, DCS800
Boards
RDCU, RMIO, SDCS-CON-4, SDCS-POW-4, AINT, AIMA, RAIO, DDCS
Keypads
ACS-CP-U, ACS-CP-C

Typical faults

What comes in

  • IGBT short circuit and overcurrent trips
  • DC-bus overvoltage and undervoltage
  • Earth fault
  • Gate-driver board failure
  • Control-board power-supply failure
  • Keypad and panel communication faults
  • Fan and overtemperature faults

What we do: Fault tracing to component level, IGBT replacement with gate checks before power-up, DC-bus capacitor reforming or replacement, parameter backup and restore (Drive Composer where supported), full-load test and a 6-month warranty.

IGBT power stage and gate-driver boards of an industrial VFD under repair
Fig. 02IGBT power stage and gate-driver boards

Tested before it leaves

Full load, every time

Every repaired ABB drive runs with a motor at rated current for at least 30 minutes before dispatch, and ships with a test report and a 6-month warranty.

See the lab

How it works

Sending us a ABB drive

  1. Send it or we collect it

    Pickup across Jamshedpur, Adityapur, Gamharia and the wider region.

  2. Free inspection

    We find the fault and send a written quote, normally by the next day.

  3. Repair

    Only after your approval. Failed parts replaced with matched components.

  4. Full-load test

    At rated current for at least 30 minutes, with a test report.

  5. Back to you

    Packed, delivered, with a 6-month warranty.

Electronic Point is an independent repair workshop and is not an authorised service provider of ABB. ABB and its product names are trademarks of their owner, used here only to describe the equipment we repair.

Other makes: Siemens · Toshiba · Yaskawa · Delta · Schneider · all makes

Breakdown support

ABB drive down? Send us the nameplate.

A clear photo of the nameplate and the fault code on the display is usually enough for us to tell you what's likely wrong and what it will take.